The following is a series of videos to guide you through the process of upgrading your GB3 to a GB3+.
Important Safety Information: Disconnect your Gigabot from power and make sure it is turned off during the upgrade process!
1. Bed Frame Removal
2. Bed Hardware Removal
3. Side Plate Replacement
4. Leveling Knob and Rear Wheel Installation
5. Extruder Replacement
6. Corner Plate Replacement
7. Bed Frame Installation
8. First Z Home and Cable Carrier
9. Bed Movement Cycling
10. Z Upper and Lower End Stop Adjustment
11. Side Panel Re-installation
12. Spool Holder Replacement
13. Viki Enclosure Replacement
14. GB3+ LED Light Strip Installation
15. LED Light Strip Wiring
16. GB3+ Nameplate Installation
Questions or concerns? Reach out to our support team at support@re:3D.org or open a support ticket.
0 Comments