Follow

Filament Detection Installation

Save your prints, reduce wasted filament, and enjoy easier completion of print jobs with re:3D Filament Detection. This upgrade enables your Gigabot to automatically detect when your filament has run out. It will respond by pausing the print and waiting for you to manually replace the filament and resume the print.

Tools Needed: 

  • 3mm Allen key
  • Needle nose pliers

Important Safety Information: Disconnect your Gigabot from power and make sure it is turned off during the installation process!

To install Filament Detection, please follow the instructions outlined in this PDF. While the video below does not contain installation instructions, it demonstrates the functionality of Filament Detection in your Gigabot. 

Filament Detection Wiring Diagram 

Filament Detection Edit Log

Questions or concerns? Reach out to our support team at support@re:3D.org or open a support ticket

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.