Z-Axis Motor Twitching


Please swap the Z axis stepper motor drivers as shown in the photo below. Additionally, refer to the Azteeg X3 Pro Wiring Diagram for further assistance. 


Does the twitching occur on the same motor or does it move to the other?

  • If it moves to the other motor, the Z-axis stepper driver likely needs replaced. Replace the corresponding driver for the problematic extruder. Refer to the Azteeg X3 Pro Wiring Diagram
  • If the issue persists, the motor wire may be defective, or the motor itself may be defective. 

Questions or concerns? Reach out to our support team at or open a support ticket


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Please sign in to leave a comment.