Follow

Removing the Bed

If you suspect your Gigabot's bed is warped, re:3D will test it to confirm. Follow the steps outlined below to remove the bed, which will then need to be shipped to re:3D's factory technicians.

Instructions: 

1. Unplug the thermocouple and heater wires, outlined in the photo below.

thermocouple_heater_wires.png

2. Remove the four bolts securing the bed to the rails. One is shown below for reference. 

bed_rail_bolt.png

Questions or concerns? Reach out to our support team at support@re:3D.org or open a support ticket

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.