Removing and Installing the Electrical Box Cooling Duct

Tools Needed: 

  • 5.5mm wrench
  • 2.5mm Allen key
  • Large flat head screwdriver

Important Safety Information:

Make sure the hot ends are cool, then turn off and unplug the Gigabot from power during the removal and installation processes.


To remove the cooling duct, first open the electrical box with a large flathead screwdriver or a quarter. Next use a 5.5mm wrench to secure the nut and a 2.5mm Allen key to unscrew the two screws that hold the electrical box cooling duct in place as shown below.


To install the cooling duct, do these steps in reverse.


Questions or concerns? Reach out to our support team at or open a support ticket

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Please sign in to leave a comment.