GIGABOT TROUBLESHOOTING

KLIPPER ISSUES

• Common Errors and Troubleshooting

ELECTRICAL ISSUES

• Confirming a Bad Relay
• Confirming a Bad Fuse
• SD card not recognized by the Viki LCD Screen
• Part Cooling Fans Not Turning Off
• Measuring the Bed Heater Pad resistance
• Head Cable Continuity Testing

See all 8 articles

ERROR MESSAGES

• Error: Mintemp Bed
• Thermal Runaway Error
• Max Temp Error
• Heating Failed Error

Miscellaneous Issues

• Bed Adhesion Issues
• Print Shifts

EXTRUSION ISSUES

• Contaminated Materials
• Performing a "Cold Pull"
• Excessive Filament Tube Friction
• Gigabot X Extrusion Issues
• Removing Filament Stuck in the Hot End
• Filament Extrusion Issues

See all 8 articles

FIRMWARE

• Klipper Firmware Installation
• Procedure for PID Tuning Gigabot 4 and Terabot 4 Dual Extruder Hot Ends
• Gigabot Firmware Installation
• Tuning the Hot End Temperature Controller (PID Tuning)

PRINT INTERRUPTION

• Troubleshooting Electrical System for Gigabot Resets
• Check 24V Power Supply Output
• Recovering a Print
• Gigabot Stops Mid Print and is Unresponsive
• Grounding the Viki LCD Screen

FILAMENT DETECTION ISSUES

• False Filament Detection
• Failed Filament Detection

MOTOR ISSUES

• Z-Axis Motor Twitching
• Swapping Y-Axis Motor Drivers
• Motor Cable Continuity Testing
• Loose Motor Pulley

SQUEALING/UNUSUAL MOVEMENT

• Z-Axis Squealing and Layer Height Adjustment
• Extra Movement in the X, Y, or Z-Axis
• Testing Homing and Limit Switches