We all know OGB is pretty cool, but mine seems to be learning!!!
When we first got the bed heating issue fixed it was taking 47 minutes to heat from 21C to 95C to print ABS.
Its now only taking 25 minutes...
Boggle?
I'm not aware of any changed procedures and I am still using the same USB connection from my computer to OGB from Pronterface. Most curious.
Anyone else observe this behavior?
47 minutes sounds a little long. Was the difference having the hood open or closed?
No, because the only reason I was printing ABS was to remake the Extruder cold ends that had warped the previous time that I had printed ABS with the hood closed - so never doing that again - heating bed to 95C with the hood closed that is.
I saw a comment about using a bed cosy to help reduce bed heating time that seemed interesting...
Hey Shawn,
Has the temperature within the room changed much, or is there a fan close by that could be removing heat?
As awesome as that would be, the OpenGB does not have artificial intelligence.
A heat graph might help us to figure out what's going on but if you're not getting the behavior anymore that will be tough!
- Mike