Look for some helps guys/gals,
We have had our Gigabot 3+ for about a month and a half and have been having some problems recently. We have printed a handful of these pieces and on our most recent one we have been getting what looks like the outer most perimeter missed the layer below it and now we have these strings on the side of the piece. It looks like the missed perimeter layer plays into the top layers filling all the way to edge, like what happened around the circle and at the radius at the top.
We also seem to have a good bit of offset from when we did a filament change.
Any help on what we would need to look at or adjust to alleviate these problems would be greatly appreciated.
