Carlos Pozo
- Total activity 113
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 2
- Subscriptions 33
Comments
Recent activity by Carlos Pozo Sort by recent activity-
re:3D - Agent thanks. I will check my thermocouple. you are right, the cables might have came loose
-
Finally got it installed and tested. It worked for the first part but now it just error with MAX TEMP.
-
here are the stls fo dual size heads, left 1.75 or right 2.85mm: 3 Items
-
the layers look really bad, so I am guessing maybe the extrusion multiplier is a bit to low for the speed or the hot end a little too cool?
-
my other guess is that needs a bit more retraction, maybe it deposited more plastic at some point where the nozzle or something in the head grabbed to and pulled dislodging the part
-
it looks like the separation between the support and the raft is not the right amount and because the part is held on a small area at the beginning it runs the risk of this to happen. Also it could...
-
I tried using the hex file and throws this error at 97% complete
-
I tried using the hex file and throws this error at 97% complete
-
thanks Matthew, for the recommendations I did change all the inside parts to ABS I had to learn the hard way. I had my first enclosure version 19 inch tall. and when the chamber got to 100C ...well...
-
Sigbjorn, I am debating about it.