Carlos Pozo
- Total activity 113
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 2
- Subscriptions 33
Comments
Votes on activity by Carlos Pozo Sort by votes-
the layers look really bad, so I am guessing maybe the extrusion multiplier is a bit to low for the speed or the hot end a little too cool?
-
thanks Matthew, for the recommendations I did change all the inside parts to ABS I had to learn the hard way. I had my first enclosure version 19 inch tall. and when the chamber got to 100C ...well...
-
Sigbjorn, I am debating about it.
-
I only leveled my bed once; the time I bought my GB2 that was 3 years ago. Still pretty good. Even when I switch between .4 and .5 nozzles. (Now that I said this I will have a catastrophic failure...
-
Homedepot. They sell a box of assorted springs
-
Nile, Amazon, sparticus, spartan, brick layer, spark plug, prime, Triton,
-
I would love to have a resume print from layer capability. Specially when the print fails after 50 hours of printing :-)
-
re:3D - Agent thanks. I will check my thermocouple. you are right, the cables might have came loose
-
Finally got it installed and tested. It worked for the first part but now it just error with MAX TEMP.
-
here are the stls fo dual size heads, left 1.75 or right 2.85mm: 3 Items