Sigbjørn Thorsen
- Total activity 36
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 9
- Subscriptions 11
Activity overview
Latest activity by Sigbjørn Thorsen-
Sigbjørn Thorsen created a post,
Filament Change Routine
Hi :) After I updated firmware to 4.1.3, my machines does not do the usuall filament change routine.Usually it moves to X300,Y300 before it starts retracting etc.This is what I want.Now it homes, a...
-
Sigbjørn Thorsen commented,
Please post solution on the board if you figure it out, so it will be easier for others in the future :)
-
Sigbjørn Thorsen commented,
Looking good Carlos! Keep us updated on your progress :) Edit: Are you planning on having the filament roll inside the chamber aswell?
-
Sigbjørn Thorsen commented,
Might be wrong but heres my guess:Overhangs need support, even on the inside! Its easy to forget but this model was printed with to little infill, maybe to few top layers aswell, so the continues h...
-
Sigbjørn Thorsen commented,
Ah yeah! #feelsgoodman
-
Sigbjørn Thorsen commented,
The one on the right is printed with a larger nozzle and layer height.The nozzle's extrusion width is larger than most of the letters embossed.So you get ugly artifacts where some parts of the lett...
-
Sigbjørn Thorsen commented,
I've had quite good results using HT-PLA. Can withstand temperatures upto 100C after tempering/baking.Just be careful when you bake it, and make sure to leave all the supports on as when it heats u...
-
Sigbjørn Thorsen commented,
Wow that looked great :)thats great news man, thanks for putting my mind at ease.Figured i'll print out some new brackets for those that are above the bed like you did, and i'll be golden :)
-
Sigbjørn Thorsen commented,
I am aware that the printed parts in PLA is the first thing to go should the temp reach higher than 50 degrees. Any suggestions what material I should print new parts in?:)
-
Sigbjørn Thorsen commented,
Go big or go home Mike :')