Mike Battaglia
- Total activity 130
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 25
- Subscriptions 57
Activity overview
Latest activity by Mike Battaglia-
Mike Battaglia commented,
Nice job on the filament detection relocation.
-
Mike Battaglia commented,
Official comment Hi Mike, We use the Tend camera but there are a lot of options these days including Nest and Arlo. The camera is usually wide angle and gets a good portion of the bed.
-
Mike Battaglia commented,
Official comment Hi Daniel, Matthew's original post was likely intended to assume you are using a PrintinZ or Buildtak surface. Buildtak is what we used to sell but have switched to our own PrintinZ surface which ...
-
Mike Battaglia commented,
Hi Daniel, The change filament script is meant to kick in when A. the hot end heater turns on and B. there is no filament in the filament detector. Are you sure that your filament is going into the...
-
Mike Battaglia commented,
Official comment Hi Andrew, Are you using our standard layer heights? If you are hearing a high pitched squeal, it can be avoided by using our layer heights and slightly tweaking the Z home position until you no lo...
-
Mike Battaglia commented,
Official comment Hi Raymond, If you'd like to use the 220 bed we can send over some rewiring instructions. The relay should be the same. I'd recommend shipping the Gigabot to Houston for the full upgrade; we can re...
-
Mike Battaglia commented,
Hi Mario, GB2 only came as a single extruder machine. What is you serial number? Please write into support@re3d.org for faster service, thanks!
-
Mike Battaglia commented,
Hi Mario, you can usually reduce the triangles by quite a bit before it's something that can be noticeable on the finished part. If you start to see a difference in the quality on the computer rend...
-
Mike Battaglia commented,
Hi Mario, How soft does the mold need to be? I typically would 3D print the positive and use traditional mold making tools from Smooth On. There are a lot more options in material when you make a t...
-
Mike Battaglia commented,
Mario, please also attach a picture of the hot end when you email support@re3d.org. It typically means that the nozzle hasn't been tightened enough and there is material leaking out of the threads...