Mike Battaglia

Total activity 130
Last activity March 07, 2019 20:49
Member since January 30, 2015 17:28

Following 0 users
Followed by 0 users
Votes 25
Subscriptions 57

Comments

Recent activity by Mike Battaglia

Nice job on the filament detection relocation.
- View comment
- Mike Battaglia
- Created March 07, 2019 20:49
- 0 votes
Official comment
Hi Mike, We use the Tend camera but there are a lot of options these days including Nest and Arlo. The camera is usually wide angle and gets a good portion of the bed.
- View comment
- Mike Battaglia
- Created January 04, 2019 19:15
- 0 votes
Official comment
Hi Daniel, Matthew's original post was likely intended to assume you are using a PrintinZ or Buildtak surface. Buildtak is what we used to sell but have switched to our own PrintinZ surface which ...
- View comment
- Mike Battaglia
- Created January 02, 2019 17:37
- 0 votes
Hi Daniel, The change filament script is meant to kick in when A. the hot end heater turns on and B. there is no filament in the filament detector. Are you sure that your filament is going into the...
- View comment
- Mike Battaglia
- Created December 20, 2018 16:53
- 0 votes
Official comment
Hi Andrew, Are you using our standard layer heights? If you are hearing a high pitched squeal, it can be avoided by using our layer heights and slightly tweaking the Z home position until you no lo...
- View comment
- Mike Battaglia
- Created August 16, 2018 20:57
- 0 votes
Official comment
Hi Raymond, If you'd like to use the 220 bed we can send over some rewiring instructions. The relay should be the same. I'd recommend shipping the Gigabot to Houston for the full upgrade; we can re...
- View comment
- Mike Battaglia
- Edited May 02, 2018 16:44
- 0 votes
Hi Mario, GB2 only came as a single extruder machine. What is you serial number? Please write into support@re3d.org for faster service, thanks!
- View comment
- Mike Battaglia
- Created March 07, 2018 15:29
- 0 votes
Hi Mario, you can usually reduce the triangles by quite a bit before it's something that can be noticeable on the finished part. If you start to see a difference in the quality on the computer rend...
- View comment
- Mike Battaglia
- Created February 26, 2018 17:11
- 0 votes
Hi Mario, How soft does the mold need to be? I typically would 3D print the positive and use traditional mold making tools from Smooth On. There are a lot more options in material when you make a t...
- View comment
- Mike Battaglia
- Created February 23, 2018 15:39
- 0 votes
Mario, please also attach a picture of the hot end when you email support@re3d.org. It typically means that the nozzle hasn't been tightened enough and there is material leaking out of the threads...
- View comment
- Mike Battaglia
- Created January 03, 2018 00:51
- 0 votes