re:3D Support
- Total activity 154
- Last activity
- Member since
- Following 2 users
- Followed by 0 users
- Votes 6
- Subscriptions 78
Activity overview
Latest activity by re:3D Support-
re:3D Support created an article,
Replacing a Hot End and Thermocouple Assembly
Overview: Some hot ends come preassembled with a thermocouple. Please follow these instructions to replace the assembly. Instructions: Gigabot: Use the Viki to lower the bed to Z=300mm Heat the ...
-
re:3D Support created an article,
Gigabot Calibration Procedures
Overview Gigabot and Terabot are precision machines, so they need to be maintained appropriately to ensure they function as intended. This article puts all of Gigabot's calibrations in one place so...
-
re:3D Support commented,
Official comment Hi Stan, Sure thing! These are located on our SketchFab profile here: Link. The parts you need are the "Cold-End Tensioner", "OGB: Left Extruder", and "OGB: Right Extruder". We recommend printing t...
-
re:3D Support commented,
Great update Helen! Lots of interesting data and good engineering
-
re:3D Support created an article,
Printing G-Code files over the USB Cable
In this article we will walk you through how to print with the USB cable. This is not recommended for normal operation, but is especially useful when troubleshooting your printer. It can be used to...
-
re:3D Support created an article,
Replacing the Viki Wiring Harness
The Viki wiring harness connects the Viki LCD screen to the Azteeg control board. Its correct installation is crucial to the proper functionality of the electrical system. If your Viki wiring harne...
-
re:3D Support created an article,
SD card not recognized by the Viki LCD Screen
In the event that the SD card is not recognized by the Viki LCD screen, here are the troubleshooting steps that you should follow to isolate the issue: Suggestions: Turn the printer off and then b...
-
re:3D Support commented,
Official comment Patrick Satyshur Hi Patrick, thank you for your question in our forum. These "Left Cool" and "Right Cool" settings are the temperatures the hot ends are set to when they are NOT the hot end that is...
-
re:3D Support created an article,
Replacing the LED Light Strip
In the event the LED light strip on the inside front rail of the Gigabot needs to be replaced, please follow these instructions: Turn off and unplug the Gigabot from the outlet Remove the cover on...
-
re:3D Support created an article,
Printing the Unibody Extruder
The unibody extruder was the precursor to the current all-metal extruders that ship on Gigabot. For those that would like a replacement of the unibody, you can follow these instructions to print an...