Jesse West1969

Total activity 8
Last activity September 25, 2018 13:57
Member since November 28, 2016 14:41

Following 0 users
Followed by 0 users
Votes 0
Subscriptions 4

Activity overview

Latest activity by Jesse West1969

Jesse West1969 commented, September 25, 2018 13:57
I use a similar setup on my printer. I also run mine with the side plate->rail screws loose. My bed floats on the four corners bolts as shown. It also eliminates any binding on the z-axis travel th...
- View comment
- Jesse West1969
- Created September 25, 2018 13:57
- 0 votes
Jesse West1969 commented, September 25, 2018 13:51
I have recently upraded my Gigabot 2.0 to the latest Marlin firmare 1.1.9. I highly recommend this version because it has Bed leveling without a probe. (manual probing using the nozzle and a piece ...
- View comment
- Jesse West1969
- Created September 25, 2018 13:51
- 1 vote
Jesse West1969 commented, November 28, 2016 17:25
Let me add my 2 cents here, I agree with what Matthew says about the nozzle being slightly to close to the print bed on the first layer. I was experiencing similar problems when I printed parts on ...
- View comment
- Jesse West1969
- Edited November 28, 2016 17:32
- 0 votes
Jesse West1969 created a post, November 28, 2016 14:41
Gigabot 2.0 energy chain
1. Community
2. Show & Tell
I have designed and printed my own energy chain for my gigabot. I had to re-route the wiring, but now have tamed the original wiring mess that was putting stress on the moving mechanism. I am curre...
- Jesse West1969
- Edited November 28, 2016 14:57
- 2 followers
- 1 comment
- 1 vote