Brett Richardson
- Total activity 9
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 3
Activity overview
Latest activity by Brett Richardson-
Brett Richardson commented,
Movement speed too high for the mass of the hot end with the pellet extruder? That doesn't make a ton of sense since it's a circular print and probably never got going that fast in those two direc...
-
Brett Richardson commented,
Are the defects distributed over the entire cylinder or are they biased to a direction?
-
Brett Richardson commented,
Irregular granule size, or inconsistent feeding into the extrusion screw. Prevent by screening / sorting regrind, or re-melting and extruding it into pellets. Increase size of flutes in screw to ...
-
Brett Richardson commented,
Pretty much what Darrel said - enable speed over rides. It's not exactly a structural part so overkilling it shouldn't hurt too much; have it reduce speed below 30 sec layers or something along th...
-
Brett Richardson commented,
Outline direction was Inside-Out, very low or no infill and not enough outlines/perimeters.