Canadian Stormie

Shawn Fitzpatrick

May 21, 2016 04:06

Hot off the presses - needs to be cleaned up a bit still, but too much fun to not share :)

1

• 

  Mike Battaglia

  June 02, 2016 17:34

  Nice!

  0
• 

  Shawn Fitzpatrick

  June 02, 2016 17:44 Edited

  Funny part is that Matthew picked up on the loose hot end from this pic, and once I fixed that the print quality was much better. Then he noted that my extrusion rate was likely too high when he was looking at my ABS print of the tug boat test print. Once I calibrated that the prints are like 10x better than this - so at some point when I can justify the print time, I want to redo it.

  I want to figure out how to do dual head prints before I do the re-print though and print it with both black AND white :)

  0

Please sign in to leave a comment.