Samantha Reeve
- Total activity 43
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 16
Activity overview
Latest activity by Samantha Reeve-
Samantha Reeve commented,
Here's another view:
-
Samantha Reeve created a post,
December 2019 Puzzler
This print shifted. The basketball player is supposed to be cut completely through the phone case, not have pants halfway in. What caused it to shift?
-
Samantha Reeve commented,
Yes, it was printed on different generation Gigabots with different extruders. The one on the left was printed with GB2 and and the one on the right was printed on GB3+ and the file was sliced for ...
-
Samantha Reeve commented,
Our raw material is almost always consistent enough to to not give us different print qualities for the same material and color. The nozzles were physically different, but the same size from the sa...
-
Samantha Reeve commented,
This was printed inside a full enclosure, so if the office temperature did change, then this print should have been less affected by it. This was also not something we saw in any of our other print...
-
Samantha Reeve commented,
You are correct that the smaller layers have heat build up and can't cool down and the way to fix it is to slow down the layers, but that doesn't change the color much. That affects the warping of ...
-
Samantha Reeve commented,
Congratulations! We will send you a coupon code to redeem your prize of a 5lb spool of PLA. The correct answer was to add a cooling fan. One key clue is the middle of the part that shows a clean p...
-
Samantha Reeve created a post,
August 2019 Puzzler
We have been testing GBX and printing geometries to test the limits of the printer. These dodecahedrons were printed with ground up PLA from previous failed prints. The two prints in the picture be...
-
Samantha Reeve created a post,
July 2019 Puzzler
We have been grinding up our rafts, supports, and failed prints from normal Gigabot to print on Gigabot X. This is a GBX test print using regrind silver PLA from normal Gigabot prints. It is spiral...
-
Samantha Reeve commented,
The rocket printed at default Simplify settings. It had the same layer height (0.3175mm) throughout, same temperature (210C), and slowed down to a max of 25% for layers less than 7s. In the picture...