Gigabot Getting Started Guides

Gigabot 3+

If you received a Fully Assembled Gigabot 3+, please click on the photo of the PDF instruction manual below to get started.

Terabot

If you received a Terabot, please click on the photo of the PDF instruction manual below to get started.

Gigabot X

If you received a Gigabot X, please click on the photo of the relevant PDF instruction manual below to get started.

For Gigabot X2 printers, use the instructions PDF below:

For older versions of Gigabot X with Marlin firmware, an Azteeg board, and a Viki, use the below PDF instruction manual:

Terabot X

Exabot

If you received an Exabot, please click on the photo of the PDF instruction manual below to get started.

Questions or concerns? Reach out to our support team at support@re:3D.org or open a support ticket.