Samantha Reeve

Here's another view:

Yes, it was printed on different generation Gigabots with different extruders. The one on the left was printed with GB2 and and the one on the right was printed on GB3+ and the file was sliced for ...

Our raw material is almost always consistent enough to to not give us different print qualities for the same material and color. The nozzles were physically different, but the same size from the sa...

This was printed inside a full enclosure, so if the office temperature did change, then this print should have been less affected by it. This was also not something we saw in any of our other print...

You are correct that the smaller layers have heat build up and can't cool down and the way to fix it is to slow down the layers, but that doesn't change the color much. That affects the warping of ...

Congratulations! We will send you a coupon code to redeem your prize of a 5lb spool of PLA.  The correct answer was to add a cooling fan. One key clue is the middle of the part that shows a clean p...

The rocket printed at default Simplify settings. It had the same layer height (0.3175mm) throughout, same temperature (210C), and slowed down to a max of 25% for layers less than 7s. In the picture...

The rocket is PLA and was printed with a nozzle temperature of 210C. What temperature should it be changed to? Why change the temperature? 

Sigbjørn, Does it do the same thing and go to the wrong place when you force it into filament detection? You can force it into filament detection by going to Prepare/Tune-> Change Filament-> Change...

Currently this program just works for single extrusion and ditto prints. Dual extrusion recovers will try to print with the wrong nozzle for a layer.