Jake Celmo

 OverviewOn printers running Marlin firmware, the EEPROM (Electrically Erasable Programmable Read-Only Memory) stores key user-configuration settings so they persist after power cycles. This includ...

If you have recently re-flashed or updated the Firmware on your Machine and are missing one of your Heaters/Extruders, the following steps will help correct the Machine's Configuration:First Naviga...

High-temperature materials such as ABS and polycarbonate (PC) require a warm printing environment to print successfully. For these materials, the ambient air inside the printer enclosure should typ...

Removing the extruder should not be the first troubleshooting step. In most cases, issues can be identified and resolved without disassembly. However, if troubleshooting indicates that extruder rem...

Overview:Before proceeding, it’s important to understand that the GB3+ dual extruder wiring harness includes three different groups of fans, each with a specific purpose. These fans perform differe...

Instructions:  Turn off and unplug the Gigabot from the outlet Using a 2.5mm Allen wrench, take off the back cover of the print head by removing the two screws shown below: Remove the two fan ...

The minimum bed temperature required to start and maintain a print is 5°C (41°F); otherwise, the printer will display 'mintemp bed error'.The likely causes of mintemp bed errors: Ambient temperatur...

OverviewImportant Note About Nozzle Replacement:Replacing a nozzle on a Gigabot is a precision procedure and is not recommended unless you have the proper tools and experience, including the use of...

OverviewThe sections in this instructions guide include: Reasons for Removing or Installing a Gigabot X Nozzle Removing a Gigabot X Nozzle Installing a Gigabot X Nozzle Removing the Nozzle Receiver...

If the printer is experiencing power-related issues, you may need to verify that the power supply is correctly outputting 24 VDC. Follow the steps below carefully to measure the power supply output...