Follow

Power and Z-Limit Switch Relocation

This upgrade will allow you to relocate the power switch and Z limit switch on your Gigabot. You will find that this is especially helpful for making easy adjustments on the Z end stop screw if you have side panels installed on your machine. Additionally, the new power switch location will make it much more convenient to power off your Gigabot.

Tools Needed: 

  • 3mm and 1.5mm Allen key
  • 5/16" or 8mm wrench
  • Needle nose pliers
  • Crescent wrench
  • Power drill
  • 3/8' and 1/8" drill bit
  • Right angle screwdriver
  • Small flat head screwdriver
  • Small Phillips head screwdriver

Important Safety Information: Disconnect your Gigabot from power and make sure it is turned off during the following process!

Please refer to the PDF instructions to guide you through this process. If you prefer video instructions, please follow the steps outlined in the video below. 

Questions or concerns? Reach out to our support team at support@re:3D.org or open a support ticket

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.