Klipper Flow Rate

For an in-depth guide, visit Orca Slicer's wiki: https://github.com/OrcaSlicer/OrcaSlicer/wiki/flow-rate-calib

*Flow rate testing is only supported for filament based printers. 

*Semi-auto calibrations are supported in re:3D Klipper OS as of v1.3.0

1. Start off by entering global parameters based on your printer type and material. Make sure to click 'Set Parameters' to activate the profile.

   

2. Scroll down to the Flow Calibration section.

   

3. Click 'Start Calibration' to begin printing the test artifact based on the global parameters. You can navigate back to 'Printer Control' to check progress.
4. Wait for the print to finish. 

5. Each object that is printed has a different flow modifier number. 

   

6. What you are looking for is the object which has:
   1. The smoothest top surface.
   2. No visible gaps between the pattern arcs.
   3. Minimal or no visible line between the inner spiral and outer arcs. 
   4. 
7. To get your flow multiplier: (object's modifier number + 1). So for example if the object is -.01, then (-0.01 + 1) = 0.99
8. Input this flow multiplier into the Flow Calibration section and submit results.