-
Top enclosure concept 1 vote 6 comments -
Testing Fiberlogy HD PLA 1 vote 1 comment -
E3D Volcano Hot End 1 vote 6 comments -
2016 Holiday Ornament! 1 vote 1 comment -
Gigabot 2.0 energy chain 1 vote 1 comment -
Printing with a .8 nozzle 0 votes 2 comments -
ABS top & bottom layer problems with E3D allmetal hot end 0 votes 2 comments -
Correct format for SD card 0 votes 3 comments -
Viky gcode files 0 votes 4 comments -
printing ABS with the E3D all metal hotend 0 votes 17 comments -
Repetier-Server Settings 1 vote 1 comment -
Affects of temperature on thin walled prints 1 vote 0 comments -
filament detection at the head -1 votes 0 comments -
Resume print from layer for 50+ hour prints 0 votes 2 comments -
Quick change heads for GB2 1 vote 3 comments -
PC filament 0 votes 3 comments -
Thoughts on what is causing this? 0 votes 5 comments -
Parameters for .8 mm Nozzles 0 votes 2 comments -
New Octoprint help manuals up on Wevolver 0 votes 5 comments -
Filament rack mod for 15 lb rolls 0 votes 3 comments -
Wiring steppers in series vs parallel 0 votes 3 comments -
Community Update with Important App Information 1 vote 2 comments -
July Puzzler 0 votes 2 comments -
New GB3 Firmware 4.1.3 0 votes 15 comments -
Encoder Addition 0 votes 1 comment -
OpenGB Print Hangs 0 votes 0 comments -
Board used by openGB 0 votes 11 comments -
Filament holding 0 votes 3 comments -
Ground wire for heated bed 1 vote 0 comments -
PLA / PHA 1 vote 0 comments